Grado Gold3 Cartridge Mounting:1/2 inch they were final able to

they were final able to produce a power cable that was consistent in performance from system to system

83 Volt @ 1m) 90dB Nominal impedance 8 Ohm Frequency response (-6dB typical in room) 37Hz - 28kHz Drive unit complement 1 x 200mm multi-fibre bass / midrange cone

**The 180mm x 150mm Optional top plate pack is not suitable for NeXXus Pro Studio as the overall combined depth of the twin vertical tubes is deeper than the top plate

Impedance: 42 Ω

Predator II

Grado Gold3 Cartridge Mounting:1/2 inch they were final able toGold3 Prestige Series 3 The Gold3 uses a four piece OTL cantilever with a Grado specific elliptical diamond stylus mounted on a brass bushing. With the Gold3, a machined turned generator is used to achieve a lower distortion and greater transparency. The Gold3 are hand selected from production runs which meet higher test specifications. Grados OTL, or optimised transmission line, technology provides an ideal transfer of signal from the surface of the