16 Inch Moldboard for John Deere Moldboard Plows, A20702, BA1024A Listed as "rear axle drive

Listed as "rear axle drive gear" in IH parts catalog but commonly referred to as final drive bull gear

Quantity 2 used per tractor

Often the safest  approach is to remove the lines at the pump and the Touch Control hydraulic unit to gain needed clearance

Replacement Case IH Governor Thrust Bearing Assembly part numbers: 43481D

New Transmission Input Shaft Seal for International and IH Farmall A

16 Inch Moldboard for John Deere Moldboard Plows, A20702, BA1024A Listed as "rear axle drive16" Inch Moldboard for John Deere Moldboard Plows Equipped with High Speed (HS) Plow Bottoms. Replaces John Deere and aftermarket moldboard part numbers: A20702, BA1024A, HS316, 006147, 741600, 7460, HS316C, 7435, 16994 263. Please check measurements before ordering to ensure correct fit. The High Speed (HS) series plow bottom was available on John Deere moldboard plows from 1953 through 1969. Tillage parts labeled as "New Old Stock" are from various